Weldco logo white
Products / Motor Grader Attachments / Motor Grader Snow Wings / MG Hydraulic Mastless Snow Wing (MSW102)
Request a Quote

MG Hydraulic Mastless Snow Wing (MSW102)

Mastless Snow Wings WBM Mastless Snow Wings, designed for motor graders, provide an industry leading 40” benching height capability. With the use of one hydraulic control, the operator can parallel lift the snow wing moldboard from the level ground position to the maximum benching height position.

Download Brochure & Spec Sheet »
  • Maximum operator visibility, safety and response times
  • Unprecedented 40” benching height capability
  • NEW dual rubber cushioned push pole lift stops to provide a controlled and positive stop every time the snow wing moldboard is raised
  • Combination mechanical/hydraulic float at the
    discharge (toe) end of the moldboard and
    mechanical type float at the intake (heel) for prolonged service life and greater flexibility over rough/uneven terrain
  • Simplified and compact rear mount allows reduced installation and removal times
  • Increased transport height for moldboard heel
    eliminates contact with curbs or roads while traveling
  • Stronger front mount upper H-link design to
    handle heavy loads
  • Revised moldboard cutting edge angle allows snow wing to glide easier across all terrain
  • 12’ durable performance moldboard
  • 40” benching height
  • Fully hydraulic lift
  • Manual extendable push pole with shear pin protection
  • Adjustable dual pushpole stops
  • Manually adjustable moldboard pitch control
  • Hydraulically adjustable moldboard pitch control
  • Hydraulically extendable pushpole
  • Carbide cutting edges for snow wing moldboard

A standard wing requires two sets of proportionally actuated machine hydraulics (2500 – 2750 psi @ 10 – 30 GPM flow rate). The hydraulic valve section operating the snow wing moldboard lift circuit requires float capability. One additional hydraulic control valve section is required for each optional hydraulic wing function added.

Looking for a Custom Solution?

Turn to Weldco’s Custom Engineering Team

Get Started
WBM’s in-house engineering and design team uses the latest CAD and Finite Element Analysis software to design and develop solutions to support diverse market applications. We can provide 3D solid models, in static or dynamic motion, on new products that enable you to view your attachment prior to manufacturing.